Crochet Leaf Wreath

Step-by-Step Instructions

1. 1

   Make the leaves (make 20–25)

   Chain 12. Row 1: sc in 2nd ch from hook, hdc in next, dc in next 3, hdc in next, sc in next 3, 3 sc in last ch (this is the leaf tip). Now work back along the other side of the foundation chain: sc in next 3, hdc in next, dc in next 3, hdc in next, sc in next, sl st to first sc. Fasten off leaving a 15 cm tail for attaching to the ring. Make 20–25 leaves in a mix of autumn colours.

2. 2

   Prepare the wire ring

   Wrap the wire ring completely with brown or green yarn. Hold the yarn tail against the ring and wrap tightly, covering the metal entirely. This gives the leaves something to grip and makes the wreath look finished from the back. Secure the end with a knot and trim.

3. 3

   Attach the leaves

   Use the long tail on each leaf to tie it firmly to the wrapped ring. Vary the angle and overlap the leaves generously so the ring is completely hidden. Work around the whole ring, layering leaves as you go. Mix colours and sizes for a natural look.

4. 4

   Fill any gaps

   Once all leaves are attached, check for gaps and add extra leaves where needed. You can also add small crochet berries (magic ring, 6 sc, pull tight) in red or orange for extra texture. Tie a ribbon bow at the top for hanging.

5. 5

   Hang and display

   Tie a loop of ribbon or twine to the top of the ring for hanging. The wreath is not weatherproof, so hang it indoors or in a covered porch. Store it flat in a box between seasons — the leaves hold their shape well and the wreath will last for years.